Utilize este identificador para referenciar este registo:
https://hdl.handle.net/1822/6830
Título: | Design and mechanical characterization of fibre optic plate sensor for cracking monitoring |
Autor(es): | Cruz, Paulo J. S. Diaz de Léon, Abrahams Nunes, J. P. Leung, Christopher K. Y. |
Palavras-chave: | fibre optic sensor cracking monitoring polyester OTDR |
Data: | 2006 |
Editora: | Scientific Publishing Division Myu |
Revista: | Sensors and Materials |
Citação: | "Sensors and materials". ISSN 0914-4935. 18:6 (2006) 283-299. |
Resumo(s): | The condition of many important concrete structures can be partially assessed through the detection and monitoring of cracking. Usually, crack detection in bridges is based on visual inspection. This procedure is time consuming, expensive, and unreliable; therefore, the use of cracking sensors is highly recommended. Nevertheless, most existing sensors/ transducers are quite limited in their ability to detect and monitor cracks. This paper outlines the characteristics of fibre optic sensors for crack monitoring and a describes the improvements. The proposed technique does not require prior knowledge of crack locations, which is a significant benefit over existing crack monitoring techniques. Moreover, several cracks can be detected, located, and monitored with a single fibre. An ideal application of the sensor is in the monitoring of flexural cracks in bridges, which may appear at arbitrary locations along the deck, but are essentially perpendicular to the spanning direction. This report describes recent improvements introduced in the sensor to attain the necessary mechanical properties that enable the plate to crack together with the concrete, mainly by assuring that the plate has a brittle behaviour and breaks under a small strain. Consequently, the mechanical properties after the curing of polyester were evaluated considering different combinations of catalyst and accelerant. Bearing in mind the ductile behaviour of the polyester, different particles were added to change the sensitivity of the sensor. By changing the particle size distribution, the geometry (aspect ratio) and the density of the material added, it is possible to control the sensor’s sensitivity, e.g., to obtain a sensor that detects thinner or wider cracks. For measuring and improving the adhesion of the sensor plate to concrete, a study of polyesters and epoxies as adhesives was conducted and pull-off tests were performed. |
Tipo: | Artigo |
URI: | https://hdl.handle.net/1822/6830 |
ISSN: | 0914-4935 |
Arbitragem científica: | yes |
Acesso: | Acesso aberto |
Aparece nas coleções: | CEC-EST - Artigos em Revistas Internacionais |
Ficheiros deste registo:
Ficheiro | Descrição | Tamanho | Formato | |
---|---|---|---|---|
PC 2-Design.pdf | artigo | 2,63 MB | Adobe PDF | Ver/Abrir |