Reciprocal dry sliding wear behaviour of B4Cp reinforced aluminium alloy matrix composites

dc.contributor.authorToptan, Fatih
dc.contributor.authorKerti, Isil
dc.contributor.authorRocha, Luís A.
dc.date.accessioned2013-09-12T11:32:03Z
dc.date.available2013-09-12T11:32:03Z
dc.date.issued2012
dc.date.updated2013-04-03T19:51:31Z
dc.descriptionManuscript Draftpor
dc.description.abstractIn the present work, AlSi9Cu3Mg alloy matrix composites reinforced with 15 and 19% (vol.) B4Cp were produced by squeeze casting route at 850 °C under low vacuum. Titanium-containing flux (K2TiF6) was used to promote the wetting between B4C and liquid aluminium metal. It was found, from the microstructural observations, that the wetting improved by the formation of a thin Ti-rich reaction layer. In order to investigate the wear properties, the samples were subjected to reciprocating wear tests against AISI 4140 pin under dry sliding conditions. Effect of B4C volume fraction, sliding velocity, applied load and sliding distance on reciprocal dry wear behaviour of composites was studied using general full factorial experimental design. Effects of factors and interactions on the coefficient of friction (COF) and the wear rate values of both composite specimens and counter materials were studied. Worn surfaces and wear debris were characterised using field emission gun scanning electron microscope (FEG-SEM), Energy Dispersive X-Ray Spectroscopy (EDS), optical microscope (OM) and XRay diffraction (XRD). From microstructural investigations, wear mechanism suggested as a combination of adhesive, abrasive, and delamination wear.por
dc.description.sponsorshipThis study was partially supported by TUBITAK (The Scientific and Technological Research Council of Turkey) under Grant No. 107M338. The authors would also like to thank for their kind help to Prof. O. Keles from Istanbul Technical University for experimental design studies, and Prof. J. Gomes and Mr. S. Carvalho from University of Minho for tribological studies.por
dc.distributioninternationalpor
dc.identifier.doi10.1016/j.wear.2012.05.007
dc.identifier.issn0043-1648
dc.identifier.urihttps://hdl.handle.net/1822/25151
dc.language.isoengpor
dc.peerreviewedyespor
dc.publisherElsevierpor
dc.rightsopenAccesspor
dc.subjectSliding wearpor
dc.subjectMetal-matrix compositepor
dc.subjectElectron microscopypor
dc.subjectWear testingpor
dc.subject.wosScience & Technologypor
dc.titleReciprocal dry sliding wear behaviour of B4Cp reinforced aluminium alloy matrix compositespor
dc.typearticlepor
dspace.entity.typePublicationen
oaire.citationEndPage85por
oaire.citationStartPage74por
oaire.citationTitleWearpor
oaire.citationVolume290-291por
sdum.journalWearpor
sdum.publicationstatuspublishedpor

Ficheiros

Pacote original

A mostrar 1 - 1 de 1
A carregar...
Nome:
IH-7158R1-5.pdf
Tamanho:
2.62 MB
Formato:
Adobe Portable Document Format